2. CQC/CE MPT50-12V AC/DC Single-Group Output Industrial Control Flat Power Supply Output Characteristics

3. MPT50-12V AC/DC Single-Group Output Industrial Control Flat Power Supply Physical characteristics:

4. MPT50-12V AC/DC Single-Group Output Industrial Control Flat Power Supply Safety regulation

Safety standards	IEC/EN62368-1,UL 62368-1,GB4943.1
Shock protection	Class I
Class of protection	IP20
Insulation impedance	Input-output :≥100MΩ (measured with DC500V at room temperature) Input - Ground :≥100MΩ (measured with DC500V at room temperature) Output - Ground :≥100MΩ (measured with DC500V at room temperature)
Insulation strength	Input-output :AC 3KV 50Hz 1 minute ≤10mA Input - Ground :AC 1.5KV 50Hz 1 minute ≤10mA Output - Ground :AC 0.5KV 50Hz 1 minute ≤10mA

5. MPT50 Power Supply Payment & Shipping Terms

6. Products images:

Note :

1. Unless otherwise specified, the above parameters are tested under the conditions of ambient temperature

25℃, humidity 50%, 100% load and input voltage 230Vac;

2. When working above 2000 meters above sea level, the load is derated by 7%/1000 meters;

3. Ripple and noise measurement method: use a twisted pair wire about 10mm long, and the terminal should

be connected in parallel with 0.1uf and 10uf capacitors, and measure under 20MHZ bandwidth;

4. The start time is measured in the cold start state, and rapid and frequent switching may increase the start

time;

5. The power supply should be considered as part of the components in the system. All EMC tests will be

conducted with the test sample mounted on a metal plate with a thickness of 1mm and a length of 300mm by

a width of 300mm. Verify the electromagnetic compatibility of the power supply with the terminal device;

6. When the product terminal is used, the shell must be connected to the system;

7. The test methods of all indicators in this guide are tested according to the company's standards.

Inquiry Cart 0