20U Temperature Control Wall Mount Outdoor Cabinet / Pole Mount Enclosure Single Wall With Insulation
1 Product Description
1.1 Appearance
After the cabinet is installed, as shown in below Figure
1.2 Cabinet configuration
The outdoor integrated cabinet configuration of this project is as follows:
| Cabinet type | Configuration | Quantity | Specifications |
| Main cabinet | 19 inch standard rack | 1 | 20U |
| Illumination | 1 | 48V DC, LED light |
| Air conditioner | 1 | Input voltage: AC220V 60Hz , cooling capacity: 500W |
| Emergency fan | 2 | 48V DC, bottom plate air intake |
| Grounding copper bar | 1 | M6 bolts 10 |
| Busbar | 1 | M6 bolts 10 |
| AC and DC power distribution unit | 1 | AC input: 63A/2P*1; AC output: 63A/2P*1; DC input : 63A/1P *1; DC output : 16A/1P*1; DC output : 10A/1P*3; DC output : 6A/1P*3 Circuit breaker brand: Schneider |
| Socket | 1 | 8 -bit universal socket, 220V 16A |
| Environmental monitoring system | 1 | 1* environment monitoring unit, 1U, SNMP communication; 1* smoke sensor; 1* water sensor; 1* temperature & humidity sensor; 1* tilt & shock combination sensor; 1* door sensor power supply: DC48V |
| Base sealing plate | 1 | 1 set contains 8 pieces, 2 blocks from front to back |
1.3 Cabinet size
The size of a single cabinet is shown in Figure 3 . External size: W×D×H 650×650×1150mm
1.4 Cabinet material
single layer galvanized steel + heat insulation :
Outer layer: 1.5mm galvanized steel, inner layer: 20mm PEF heat insulation
2 Cabinet installation
2.1 Unpacking
Outdoor integrated cabinets are generally packed in wooden cases. When disassembling the package, take care to avoid damage to the cabinet.
2.2 Floor, wall hanging, pole installation steps and dimensions
1 ) Landing
Floor installation effect diagram
Cabinet base size and base expansion bolt fixing hole position
2 ) Wall mount
Wall mounting effect diagram
Wall mounting steps
Wall mounting size diagram
3 ) Pole
Pole mounting effect diagram
Pole mounting steps
Pole size
2.3 Base sealing plate
If you need to seal the base of the cabinet, use the base sealing plate (optional) to seal the notch and hole around the base. The mounting screws are the M5 stainless steel screws in the cabinet attachment (see Figure 4 ).
Figure 4
Note: If the cement foundation is not flat, it is recommended to use a gasket or spacer to level the base of the cabinet.
3. Cabinet picture
